Furnace and air conditioning service in Flamborough

Yes. Flamborough is part of the area we serve from Binbrook. Call or use the contact page and describe what the furnace is doing: no heat, cold air, a fault light or a strange noise. A technician calls you back to arrange the visit, finds the fault and gives you a written price before any part is fitted. You can read more on our furnace repair page.

In the tighter houses built around Fall Fair Way and Fletcher Road, the furnace is sometimes larger than the house needs. An oversized furnace heats quickly, shuts off and starts again soon after, which leaves rooms uneven and wears the parts harder. A dirty filter or closed registers can cause similar swings. Start with the simple things: change the filter, open every register and make sure the thermostat is not near a heat source. If the swings continue, sizing may be the cause, which matters most at replacement time. See furnace installation and replacement.

Usually the fan is running but the burners have not lit, or have shut off. Check that the thermostat is set to heat and the fan to auto, because the 'on' setting moves air whether the furnace is heating or not. A very dirty filter can make the furnace overheat and shut the burners down while the fan keeps going. On a high-efficiency furnace, a blocked condensate drain or snow over the side-wall vents does the same. If those look fine, the igniter, flame sensor or gas supply are next, and those are for a technician. More in our guide on why a furnace blows cold air.